Components And Accessories - Vitek VTD-TND5RFE-2 Quick Start Manual

Components and Accessories

Camera Quick start guide
Hex Wrench
Overview
Cable Connections
First connect the Water-
proof Cap to an Ethernet
patch cable, then
connect the cameras
ethernet adaptor. If not
powering the camera
with PoE, also connect
the power Cable to an
approved 12VDC Power
Supply.
Weather Resistant Network Coupler
1. Loosen the nut from the Weather Resistant Network Coupler,
2. Run ethernet cable through coupler, then attach a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
4 tapping screws PA 4×25
Drill template
Network Cable
Power Cable
2
×4
Plastic plug
DC12V
Rubber plug