Manual Recording - Philips CDR950BK99 Instructions For Use Manual

Manual recording

Important:
- Recording from CD-changers should always be started in the
RECORD DISC, RECORD TRACK or MAKE CD mode.
- Only make analog recordings when digital recording is not
possible.
Preparing for manual recording
1 Make sure the disc is absolutely free of scratches and dust
particles.
2 Press SOURCE repeatedly until (depending on the
connection used):
DIGITAL I d, DIGITAL I I d, OPTICAL I p or ANALOG
a lights up and DIGITAL 1, DIGITAL 2,
OPTICAL or ANALOG will appear on the display.
REM REC TIME TRACK TOTAL
DIGITAL I I
PROGRAM
OPTICAL I
CD
RW
ANALOG
•When Auto Track is On (default setting), track numbers will
automatically be increased during recording.
• To switch off the Auto Track function, you must enter
Menu mode.
If you wish to increase track numbers manually, press
TRACK INCR(ement) on the remote control. For further
instructions see Menu mode.
ON (AUTO): The track increments are automatically copied
from the digital source material or after 2.7
second silence during analog recording
OFF (MANUAL): Track numbers can be incremented manually
by pressing TRACK INCR(ement) on the
remote control. (Minimum track length is 4
sec.) (This can also be done in Auto mode.)
• Track numbers cannot be changed after recording.
Note: Auto track works only with Consumer Sources with a
digital output signal according to the IEC 958
(consumer part) audio standard.
RECORD
REM TRACK TIME FADE STEP
MANUAL SYNC SCAN
SHUFFLE REPEAT TRACK ALL
3 With the recorder stopped, press REC TYPE three times to
enter the Manual Record standby mode.
starts to flash and the display shows REC
MANUAL
MANUAL.
REM TOTAL
REC TIME TRACK
DIGITAL I I
PROGRAM
OPTICAL I
CD RW
ANALOG
• If CHECK INPUT message also flashes, the digital
connection is incorrect.
4 Play the source first to set the optimal recording level on
the CD recorder.
5 Rotate the EASY JOG/ENTER key until all the blue
segments are lighted on the Record/Play Level bar but the
red segments do not light continuously during the loudest
passages.
Display shows _XX DB.
6 Stop the source.
Start recording
1 To start recording, press RECORD on the CD recorder and
immediately start the source (from stop-mode).
d lights continuously. The track number and recording
time will appear on the display.
• To record a 3-second silence at the start of a track, press
PAUSE on the CD recorder before starting the source.
• To check the elapsed recording time, press DISPLAY on the
CD recorder. (This can also be done during the recording.)
2 To stop recording, press STOP on the CD recorder.
WAIT lights up and d goes out.
• If STOP is pressed within 3 seconds after RECORD, no
recording will take place.
• To interrupt recording, press PAUSE on the CD recorder.
d starts to flash. Resume at step 1.
After recording the display will show UPDATE for several
seconds.
Note: With AUTO TRACK ON,, the recorder will stop and
go to REC STANDBY for 1 minute and then goes to stop
mode automatically. Recordings from DAT, DCC or
recordings made analogously will stop after 20 seconds
of silence. With AUTO TRACK OFF, the auto stop
mode is disabled.
RECORDING
REM FADE
TRACK TIME STEP
MANUAL SYNC SCAN
SHUFFLE REPEAT TRACK ALL
19