Advertisement
7 INSTALLATION ORDER
1) Open cover
2) Remove PCB
3а) Wall installation
3b) Bracket
Orient the base of the detector strictly
according to the figure!
4) Install PCB and
connect wires
(see. p. 8)
5) Perform testing of Ac
and PIR channels (see.
p. 9)
8 CONNECTION
Connect to the detector terminals in accordance
with the user guide for the control panel.
RELAY – terminals for connection to the alarm
loop;
TMP – tampering terminals;
GND, +12V – power supply terminals.
installation
9 TESTING
AC-channel:
1) Power on the detector. Indicator will blink
for 60 sec.
2) Activate AC-channel test mode. Mode
activates for 8 min.
3)
Close the cover.
4) With
separately) check the triggering of the detector, for
acoustic noises (when hi-frequency noise –
indicator
2 times per 1 sec; when low-frequency noise -
1 time per 1 sec).
PIR-channel:
Perform TEST-pass.
Moving through detection
zone with 0,3 m/sec speed
and 3 m/sec speed check
the sensitivity zones by
short
indicator.
glass
break
simulator
enables
of
the
10 WARRANTY
The operation warranty period is 5 years from the
date of operation start-up but no longer than 5
years 6 months from the date of manufacturing
subject to the requirements of the User guide.
(supplied
blinks
Advertisement
