Cleaning And Maintenance; Safety Advice; Cleaning - Bartscher A203.095 Instruction Manual

•
Under the influence of the temperature the chamber undergoes a slight warping
outwards and an air slit is formed as a result. It is a natural phenomenon and it does
not constitute a fault in the device. In this way is formed an airstream which removes
the condensate from the hot display top.
WARNING! Danger of burn!
The surface of the device and the containers inside heat up strongly during the
work of the device!
Do not touch the heated containers with dishes with your bare hands.
While taking out dishes, it is necessary to use protective gloves reaching above
the wrists.
•
If the device is not going to be used any more, it is necessary to disconnect it from
the power socket (take out the plug!).

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power socket (pull the power plug!!!) and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables
and the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must
not use any kind of pressure water jet for cleaning the device!

6.2 Cleaning

The device should be cleaned regularly.
o
Clean the hot display top outside and inside using a soft damp cloth and a mild
o
cleaning agent.
Clean the small scale pan regularly and remove limestone in it with the use of
o
agents available on the market.
Only use a soft cloth and make sure you never use any kind of abrasive agents or
o
pads which could scratch the surface.
After the cleaning procedure, you should use a soft and dry cloth to wipe dry and
o
polish the surface.
- 25 -