Installation And Connection; Operating - Bartscher A203.095 Instruction Manual

•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operating

•
Before first use, clean the inside of the hot display top with a soft damp cloth and a
mild cleaning agent. Dry the device carefully.
•
Clean the small scale pan for water with a damp cloth and a mild cleaning agent.
Then wash it carefully with clean water and dry.
•
Individual parts of the device should be arranged in the following way:
1. the thermometer for reading off the temperature in the hot display top –
in the right opening of the chamber;
2. the hygrometer for reading off the level of humidity in the hot display top –
in the left opening of the chamber;
- 23 -