Other Cleaning; Troubleshooting And Specifications; Troubleshooting - Toshiba VC-CL3000XBF User Manual

Table of Contents

Advertisement

Cleaning and Maintenance

Other Cleaning

When the dust sensor light does not turn on or off, the dust sensor may be dirty,
so please clean it.
Sensors
(top & bottom)

Troubleshooting and Specifications

Troubleshooting

It is strictly forbidden to modify the cleaner or accessories without
permission, and it is strictly forbidden to change the power cord or
battery without permission.
Except for specialized service technicians, please do not disassemble or repair this product.
When an exception occurs during the charging process, please unplug the power plug and
plug it in again after 15 seconds.
If the exception can't be eliminated or the operation process is abnormal, please press OFF to
stop the operation, and then check the following items.
Problem
Possible causes
- Insufficient battery power
- The power plug has just been
Do not run or
unplugged and is now in a
stop running
protected state
suddenly
- Dust cup filter is blocked
- Ambient temperature is too high
or too low
- Automatic start/stop of floor brush
- Depending on the type of carpet
Electric floor
(electric blanket, long pile or
brush does not
carpet with high pile density), the
rotate
roller brush may stop running
- The brushing area is entangled
with a lot of thread or hair
14
Solution
- Use after charging
- Wait about 3s before running
- Refer to P.12 for operation
- Please use in a suitable environ-
ment
- Refer to P.6 for operation
- Press "Off" to stop the operation
and start the vacuum cleaner
again
- Clear the hair before using
Troubleshooting and Specifications
Problem
Possible causes
The indicator
- The charging cable is not firmly
light does not
connected
light up/flash
- Charge immediately after
when charging
stopping operation
- Ambient temperature is too high
Charging time
or too low
becomes longer
- Charge immediately after use
- The environment temperature is
The suction
too high and continuous operation
power becomes
- Use automatic mode
weak during
- Continuous operation when the
operation
filter/suction port is blocked
Name and Content of Hazardous Substances in the Product
Part name
Lead
Mercury
(Pb)
(Hg)
Battery
Adapter
Lower cover assembly
Upper cover assembly
Handle
Motor assembly
Dust cup assembly
Extension tube
Electric floor brush
Accessories
Electronic circuit
Remarks:
1. This form is prepared in accordance with SJ/T11364.
2.
: Indicates that the content of the hazardous substance in all homogeneous materials of corresponding part is below
the limit specified in GB/T 26572.
3. X: Indicates that the content of the hazardous substance in one or more homogeneous materials of corresponding part
exceeds the limit specified in GB/T 26572.
4. All components marked with X in table above comply with the EU RoHS directive, namely Directive 2011/65/EU of the
European Parliament and of the Council on the Restriction of the Use of Certain Hazardous substances in Electrical and
Electronic Equipment and its amendments.
Solution
- Reconnect the charging cable
- To protect the circuit, please
wait patiently
- Please charge in a suitable environment
- To protect the circuit, please wait
patiently
- Please charge in a suitable
environment
- It is normal that less garbage is
detected and the suction power
is reduced
- Please use after cleaning
Hazardous substances
Hexavalent
Polybromo-
polybrominated
Cadmium
chromium
biphenyl
diphenyl ethers
(Cd)
(Cr(VI))
(PBBs)
(PBDEs)
15

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

Table of Contents