Setting The Display Information (Information); Setting The Item To Be Displayed (Display); Displaying The System Information (System) - Sanyo VCC-9500P Instruction Manual

Miscellaneous Settings (OPTION)
Setting the display information
A
(INFORMATION)
Sets the type and position of the information displayed on the
monitor.
OPTION
INFORMATION
AUTO FLIP
MIRROR
REFRESH
PRESET
MENU
b Setting the item to be displayed
(DISPLAY)
1
Use the joystick lever (xy) to select
[INFORMATION] – "SET y", and press the [ENTER]
button.
The INFORMATION screen appears.
INFORMATION
DISPLAY
SYSTEM
2
Use the joystick lever (xy) to select [DISPLAY], use
the lever (vw) to select "ON y", and press the
[ENTER] button.
The DISPLAY screen appears.
DISPLAY
CAMERA ID
TITLE
DIRECTION
ZOOM RATIO
3
Use the joystick lever (xy) to select the information
item, use the lever (vw) to select "ON
(displayed)/OFF (not displayed)", and press the
[ENTER] button.
Available settings:
• CAMERA ID
• TITLE
• DIRECTION (Pan/tilt angle)
• ZOOM RATIO (Magnification power in zooming)
Adjusting the display position
For [DIRECTION] and [ZOOM RATIO], you can adjust the display
position.
Selecting "ON y" for the item to adjust the display position and
pressing the [ENTER] button displays the adjusting screen. Use the
joystick lever to adjust the display position for the item.
To return to the DISPLAY screen, press the [ENTER] button again.
☞
After completing setting, use the lever to move the cursor to
[MENU] and select "BACK" or "END".
49
SET y
ON
OFF
SET y
OFF
BACK
OFF
SET
y
ON
ON
ON y
ON y
b Displaying the system information
(SYSTEM)
1
Use the joystick lever (xy) to select
[INFORMATION] – "SET y", and press the [ENTER]
button.
The INFORMATION screen appears.
INFORMATION
DISPLAY
SYSTEM
2
Use the joystick lever (xy) to select [SYSTEM] –
"SET y", and press the [ENTER] button.
The system information is displayed in the screen.
CAMERA VER
PROTOCOL
ADDRESS
BAUD RATE
TERMINATION
MENU
Setting the camera's address
If the address setting switch on the camera is set to "0", you can use
the menu screen to specify the camera's address.
1
In the system information screen, select
[ADDRESS] and press the [ENTER] button.
If the address setting switch on the camera is set to "0", the
address number is highlighted.
º ADDRESS
MENU
The initial setting for the address is "001".
2
Use the joystick lever to enter the address number.
Use the lever (vw) to select a digit to enter a number and use
the lever (xy) to select number.
3
Use the joystick lever (v) to highlight the address
again.
This completes the address setting.
Memo: After turning off and on the camera again, the address setting
becomes effective.
☞
After completing setting, use the lever to move the cursor to
[MENU] and select "BACK" or "END".
ON y
SET y
0.00-00
485S
1
19200
OFF
BACK
001
BACK