Multi-Spot Metering (Mask) - Sanyo VCC-9500P Instruction Manual

Camera Settings (CAMERA)
4
Use the joystick lever (xy) to select a zone to be
weighted and use the lever (vw) to adjust
weighting.
Selecting a zone to be weighted shows the corresponding
zone on the screen.
• TOP • BOTTOM
• LEFT • RIGHT
• CENTER [FIX] (The value is fixed to "7".)
Available settings: 0 - 7 (The larger the number, the higher
the weighting.)
☞
After completing setting, use the lever to move the cursor to
[MENU] and select "BACK" or "END".
b Multi-spot metering (MASK)
Sets backlight compensation by masking the bright area of the
background using mask patterns.
The multi-spot metering (MASK) function is available
only when registering a view setting file in the CAMERA
VIEW screen (P27).
Set [MASKING] to "ON" in the MOTION SETTING screen.
1
Use the joystick lever (xy) to select [BLC], use the
lever (vw) to select "MASK y", and press the
[ENTER] button.
The BLC MASKING screen appears. A mask pattern is
displayed in the top left of the screen.
Mask pattern
BLC MASKING
CONTINUE (y)
15
2
Use the joystick lever (xy or vw) to move a mask
pattern to the area to be excluded in metering, and
press the [ENTER] button.
This sets the mask pattern for the area to be excluded in
metering.
BLC MASKING
CONTINUE (y)
If you want additional mask patterns to be set, repeat the
above procedure.
<To delete the mask pattern>
Use the joystick lever (xy or vw) to place a mask pattern over
the mask pattern to be cancelled, then press the [ENTER]
button.
3
Use the joystick lever (y) to move a mask pattern to
the bottom area of the screen and continue holding
the lever straight down for three seconds.
This completes the mask pattern setting procedure.
☞
After completing setting, use the lever to move the cursor to
[MENU] and select "BACK" or "END".