Using The Lcd Display; Setting The Timing Mode; Osd And Power Lock Settings; Dynamic Contrast - ViewSonic VA2216w User Manual

Using the LCD Display

Setting the Timing Mode

Setting the timing mode is important for maximizing the quality of the screen image and
minimizing eye strain. The timing mode consists of the resolution (example 1366 x 768) and
refresh rate (or vertical frequency; example 60 Hz). After setting the timing mode, use the
OSD (On-screen Display) controls to adjust the screen image.
For the best picture quality set your LCD display timing mode to:
VESA 1366 x 768 @ 60Hz.
To set the Timing Mode:
1. Set the resolution: Right-click on the Windows desktop > Properties > Settings > set the
resolution.
2. Set the refresh rate: See your graphic card's user guide for instructions.
WARNING: Do not set the graphics card in your computer to exceed the maximum refresh
rate of 75Hz; doing so may result in permanent damage to your LCD display.

OSD and Power Lock Settings

• OSD Lock: Press and hold [1] and the up arrow
pressed the message OSD Locked will display for 5 seconds.
• OSD Unlock: Press and hold [1] and the up arrow
• Power Button Lock: Press and hold [1] and the down arrow
power button is pressed the message Power Button Locked will display for 5 seconds. With
or without this setting, after a power failure, your LCD display's power will automatically
turn ON when power is restored.
• Power Button Unlock: Press and hold [1] and the down arrow

Dynamic Contrast

• DCR On/Off: Press
ViewSonic VA1616w
for 3 seconds to turn DCR On or Off.
for 10 seconds. If any buttons are
again for 10 seconds.
for 10 seconds. If the
again for 10 seconds.
8