Operation; Powering On/Off The Projector - ViewSonic Pro6200 User Manual

Operation

Powering on/off the projector

Powering on the projector:
1. Complete the AC power cord and peripheral signal cable(s) connections.
2. Press to turn on the projector.
The projector takes a minute or so to warm up.
3. Turn on your source (computer, notebook, DVD, etc.). The projector automatically
detects your source.
• If you are connecting multiple sources to the projector simultaneously, press
SOURCE on the projector or Source on the remote control to select your
desired signal or press your desired signal key on the remote control.
Warning
• Never look into the lens when the lamp is on. This can damage your eyes.
• This focal point concentrates high temperature. Do not place any object near it to avoid
possible fire hazard.
Powering Off the Projector:
1. Press to turn off the projector lamp. You will see a message "Power off? Press
Power again" appear on the screen.
2. Press again to confirm.
• The cooling fans continue to operate for cooling cycle when "Auto Power Off"
function disable. No fan cooling is normally process if we turn on the "Auto
power Off" function.
• When green mode is turned off, the Power LED begins flashing and the projec-
tor has entered stand-by mode.
• When green mode is turned on, the Power LED becomes steady light and the
projector has entered stand-by mode.
• If you want to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered stand-by mode. Once in stand-by
mode, simply press
3. Disconnect the AC power cord from the electrical outlet and the projector.
4. Do not turn on the projector right after power off.
to restart the projector.
16