Download Print this page

Perfect Sun 28 2F WOLFF SYSTEM Quick Start Manual

Advertisement

Quick Links

DANGER
Ultraviolet radiation. Follow instructions. Avoid overexposure. As with
natural sunlight, overexposure can cause eye and skin injury and
allergic reactions. Repeated exposure may cause premature aging of the skin and skin cancer.
WEAR PROTECTIVE EYEWEAR; FAILURE TO MAY RESULT IN SEVERE BURNS OR
LONGTERM INJURY TO THE EYES. Medications or cosmetics may increase your sensitivity
to the ultraviolet radiation. Consult physician before using sunlamp if you are using medications
or have a history of skin problems or believe yourself especially sensitive to sunlight. If you do
not tan in the sun, you are unlikely to tan from the use of this product. Children, the elderly, or
fair skinned people who always burn easily and either never tan or tan minimally should not use
this equipment.
To use, lie down on bench and pull canopy down as far as adjustment will allow maintaining at
least 2 inches (5.1 centimeters) between your body and canopy clear plastic panel, otherwise
overexposure may occur. Do not use without clear plastic panels in place. Untanned persons
should not tan on consecutive days during their first week of tanning. Never tan more than once
a day. Tanning normally appears after the first few sessions and maximizes after approximately
four weeks. Tan once or twice per week thereafter to maintain appearance. Persons already hav-
ing a base tan may begin at advanced levels corresponding to the extent of their base tan.
Skin Type:
I
Sensitive Skin (Burns easily and severely and does not tan.)
II Light Skin
(Burns easily and severely and tans minimally.)
III Normal Skin
(Burns moderately and tans average.)
IV Dark Skin
(Burns minimally, tans easily and above average.)
RECOMMENDED EXPOSURE TIMES IN MINUTES
Level 1/Week 1
Skin Type: 1st-3rd Sessions
I Sensitive
II Light
2
III Normal
3
IV Dark
4
MAXIMUM EXPOSURE TIME IS 11 MINUTES
New lamps emit approximately 10% more ultraviolet radiation during the first 50 hours of
operation. Recommended tanning times should therefore be reduced by approximately 10%
during that period.
WARNING: • Read these instructions before using this sunlamp product. • All persons in the
room should wear protective eyewear when lamps are on. Recommended eyewear: provided
eyeshields or equivalent eyewear as defined under 21 CFR 1040.20. Other types of eyewear
may not provide adequate protection. Failure to use protective eyewear may result in severe
burns or other eye injury. If discomfort develops, discontinue use and consult a physician.
ONLY THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THE 28 2F:
PS MAX Wolff® Model PSM71-T12-100W BI-PIN
PS EXTREME Wolff® Model PSE71-T12-100W BI-PIN
Heraeus E400 HPT, Philips Model HPA 400/30s or CosmoTech Model 23045
(Facial Lamps)
DISCONNECT POWER CORD BEFORE ATTEMPTING TO CLEAN, RELAMP,
OR ENGAGE IN THE MAINTENANCE OF THIS PRODUCT.
THIS EQUIPMENT MUST BE EARTH GROUNDED.
This product is in conformity with performance standards for sun lamp
products under 21 CFR PART 1040.20 and ANSI/UL Standard 482.
Level 2
Level 3
Level 4
Level 5
NOT RECOMMENDED FOR TANNING
4
6
8
5
8
11
6
9
11
(Light Pink)
(Dark Pink)
Shock hazard.
Disconnect power before servicing or removing any protec-
tive covers.
Do not operate this device near water or while you are wet.
Some medications may increase your sensitivity to ultraviolet light. It
is recommended that you consult a physician before using this
sunbed if taking any medication or if you suspect that your skin might
be especially sensitive to sunlight.
Wear protective eyewear.
Failure to may result in severe burns or longterm injury to the eyes.
Use of a voltage source above 230V AC may prevent proper operation
of the sunbed and could cause damage and void the warranty.
Air from the room is used to cool the sunbed. Maximum ambient room
temperature should be 80°F. Place your sunbed no closer than 6" from
any wall. Make sure nothing obstructs the airflow into the sunbed's
endcaps or out of the fan openings. A poorly ventilated room may
11
cause the unit to become hot and cause discomfort to the user.
11
11
Electrical Requirements
Your sunbed operates from a 220V AC source. The 28 2F requires a
NEMA L6-30R electrical outlet (below) on a dedicated circuit capable
of providing 30 Amp service, installed in the room in which you will
use the unit. We recommend installation by a professional electrician.
The outlet must be earth grounded.
88465
DANGER
DANGER
WARNING
CAUTION
30 AMP NEMA #L6-30R
RECEPTACLE
26748-01A - Page 1

Advertisement

loading

Summary of Contents for Perfect Sun 28 2F WOLFF SYSTEM

  • Page 1 DANGER Ultraviolet radiation. Follow instructions. Avoid overexposure. As with DANGER natural sunlight, overexposure can cause eye and skin injury and Shock hazard. allergic reactions. Repeated exposure may cause premature aging of the skin and skin cancer. Disconnect power before servicing or removing any protec- WEAR PROTECTIVE EYEWEAR;...
  • Page 2 Unpacking and Inspection Hardware Inventory (These items and a small pillow) Your sunbed comes in two cardboard cartons. Pull back the plastic Allen-head Bolt 5/16” x 1” sheet and, with a helper, grasp the bench and pull it from the carton Hinge Brackets Quantity 2 bottom, leaving the plastic wrap and the carton packaging.
  • Page 3 Place the bushings Lift the canopy and hold it into hinge brackets. between the hinge brackets. Insert 5/16” x 1 1/2” bolts with nylon washers into both hinge brackets. Tighten bolts into the endcap threaded inserts until snug, then an additional half turn. Do not overtighten to avoid damaging threaded inserts.
  • Page 4 Remote Connections Setting the address manually Before connecting your sunbed to the T-Max® Manager or T-Max® 1A or 3A, the address of your sunbed must first be set. Set the address man- Your sunbed incorporates advanced circuitry allowing it to connect ually as described below.
  • Page 5 Using Your Sunbed Before using your sunbed, please note the following important pre- cautions. • Your skin should be free of cosmetics, tanning oils, or other body lotions prior to tanning except for those specifically made for use with tanning devices. However, do not remove natural body oils by bathing or showering immediately before tanning.
  • Page 6 Care and Maintenance Removing/Replacing Lamps 1. Grasp a lamp at one end and at the middle, then turn the lamp a Cleaning After Use quarter turn. The lamp may then be gently removed from its holder. Clean and disinfect your tanning bed’s bench and canopy after each 2.
  • Page 7: Troubleshooting

    3 seconds, the timer display will show the 1. Bypass plug is not installed, see Electrical Connections. sunbed’s address number. Press the stop button to exit 2. A non-Perfect Sun™ bypass has been used. address mode. 3. If remote is being used, other than T-Max® Manager, the external timer may not be activated.
  • Page 8 Perfect Sun® service person. All labor charges must be author- ized by your Perfect Sun® Dealer prior to the start of repairs and must not exceed the estab- lished rates and time allotment policies established by your Perfect Sun® Dealer. If your tan- ning unit must be returned for service, all freight charges shall be at your expense.