Panasonic WV-Q116 Instructions Manual page 3

Ceiling mount bracket
Table of Contents

Advertisement

Available languages

Available languages

WV-Q116E_E.qxd
05.2.2
Two spacer nuts are needed to use the exist-
ing anchor bolt instead.
Fall Prevention Wire
5. Attach the end of the Fall Prevention
Wire to the bracket.
5-1. Put a standard anchor nut onto
anchor bolt (2).
5-2. Remove the Fall Prevention Wire
from the Fall Prevention Angle
Clip.
5-3. Insert the anchor bolt (2) through
side "1".
5-4. Fold (manually bend the clip) side
"2" down onto side "1" (when fold-
ed properly side "1" and side "2"
should match).
5-3
5-2
Side "1"
Anchor bolts
11:05
Page 3
Spacer nuts
Spacer nuts
Fall Prevention Angle Clip
Existing anchor bolt
5-1
Side "2"
5-4
5-6
5-5
- 3 -
5-5. Reattach the Fall Prevention Wire
to the matched holes of side "1"
and "2" of the Fall Prevention
Angle Clip.
5-6. Put two standard anchor nuts onto
anchor bolt (2).
5-7. Tighten the three nuts to fix the Fall
Prevention Angle Clip.
6. Connect the Fall Prevention Wire and
put the bracket into the suspended ceil-
ing through the hole.
7. Fix the camera mount bracket to the
suspended ceiling by rotating the four
ceiling panel screws clockwise.
Anchor nut
Nuts
Clockwise
8. Mount the bracket onto anchor bolt (1).
Ceiling panel
screws
Ceiling support

Advertisement

Table of Contents
loading

Table of Contents