Table of Contents
Advertisement
Playing records
Preparation
1. Put a record on the turntable.
2. Take off the stylus cover and release the arm clamp.
1
2
To temporarily stop play
Lift the cue lever.
The stylus lifts off the record.
Refer to page 9 for fine adjustments to the pitch
When using EP records
1. Take the EP record adaptor out
of its holder and fit it over the
center spindle.
2. Press [45] to change the speed.
When play finishes
1. Lift the cue lever and move the tone arm back to the arm rest.
2. Press [start-stop].
The electronic brake gently stops the turntable.
3. Turn [power] to turn the unit off.
4. Clamp the tone arm and put the stylus cover back on.
When the player is to be used for scratch play.
Use the disc slip sheet instead of the turntable mat. This enables
the record to be easily moved during play.
•Top (printed side): Lay the record on this side.
•Bottom: Slippery side.
For a different kind of slip
Put the transparent sheet under
the disc slip sheet.
8
RQT7021
3
4,5
EP record adaptor
Disc slip sheet
Transparent sheet
1
Turn [power] to turn the unit on.
•The pilot lamp comes on.
•33 1/3 r/min is automatically selected and the indicator lights.
•Press [45] if you are playing a 45 r/min record.
Pilot lamp
2
Press [start-stop].
The turntable starts revolving.
3
Press [reset] to light the pitch control
green LED lamp.
The pitch returns to 33 1/3 or 45 r/min.
Green
LED indicator
reset
4
Lift the cue lever and move the tone arm
over the record.
5
Lower the cue lever.
The tone arm moves down and play starts.
To light up the stylus
•Press the stylus light switch. A blue LED light rises up and illumi-
nates the stylus.
•When the light is not required, press it down. The light also goes
out.
Press the switch firmly. If the switch is lightly pressed, the light may
come on but not rise up.
Indicator
lights
33
45
start • stop
33
Use the above indicated
pitch for playing standard
music.
Cue lever
Stylus light
Stylus light switch
Advertisement
Table of Contents
