Important Safety Instructions - Panasonic EY-3544 Operating Instructions Manual

Panasonic ey-3544 power tools: user guide
Hide thumbs Also See for EY-3544:
Table of Contents

Advertisement

before removing the blade from the
workpiece.
13) Do not touch the blade or work-
piece immediately after operation;
they may be extremely hot and
could burn your skin.
14) Some material contains chemicals
which may be toxic. Take caution
to prevent working dust inhalation
and skin contact. Follow material
supplier safety data.
15) When working on a ladder or on
scaffolding be sure to lay the tool
down on its side when not in use.
Some tools with large battery packs
will stand upright but may be easily
knocked over.
Symbol
V
n
0
.../min
reciprocations per minute
WARNING:
Some dust created by power sand-
ing, sawing, grinding, drilling, and
other construction activities con-
tains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals
are:
Lead from lead-based paints
Crystalline silica from bricks and
cement and other masonry prod-
ucts
Arsenic and chromium from chemi-
cally-treated lumber.
To reduce your exposure to these
chemicals: work in a well ventilated
area, and work with approved safety
equipment, such as dust masks that
are specially designed to filter out
microscopic particles.
meaning
Volts
Direct Current
no load speed
revolutions or
. FOR
BATTERY CHARGER
& BATTERY PACK
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUC-
1)
TIONS
tant safety and operating instructions
for battery charger EY0110.
2) Before using battery charger, read all
instructions and cautionary markings
on (1) battery charger, (2) battery pack.
CAUTION
3)
of injury, charge only Battery Pack as
shown below.
EY9065, EY9066, EY9168, EY9080,
EY9086, EY9180, EY9182, EY9001,
EY9006, EY9101, EY9106, EY9200,
EY9201, EY9136, EY9230, EY9231
EY9251, EY9117, EY9210
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger to rain or
snow.
5) To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6) Make sure cord is located so that it
will not be stepped on, tripped over,
or otherwise subjected to damage or
stress.
7) An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric
shock. If extension cord must be
used, make sure that:
a. pins on plug of extension cord
are the same number, size and
shape as those of plug on char-
ger.
b. extension cord is properly
wired and in good electrical
condition.
c. extension cord has a minimum
wire size of 16 AWG.
- 4 -
-This manual contains impor-
-To reduce the risk

Advertisement

Table of Contents
loading

Table of Contents