Stanley STP18 Instruction Manual page 45

Problem
Cutter head height difficult
to adjust.
Will not start.
Interrupted operation.
Cutter head will not lower
to plane material.
Possible Causes
• Dirty elevation spindle.
• Worn chain.
• Not plugged in.
• Blown circuit.
• Motor failure.
• Loose wire.
• ON/OFF switch
malfunction.
• Motor is overloaded.
• Unit overloaded.
• Circuit overloaded.
• Turret stop setting too high.
English (original instruction)
Solution
• Clean and lubricate spindle.
• Have service performed by an
authorized service center.
• Check power source.
• Replace fuse, reset breaker, or call
electrician.
• Have service performed by an
authorized service center.
• Have service performed by an
authorized service center.
• Have service performed by an
authorized service center.
• Push reset button.
• Reduce load.
• Operate on circuit separate from
other appliances or motors or
connect to circuit with adequate
amp rating.
• Lower turret stop setting.
45