Parts and their functions
1 Rotary head
This rotates in the panning direction.
3 Rotary arm
The ENG camera is mounted on this arm. The arm
rotates in the tilting direction.
This is where the pan/tilt head is held. Use it to carry the
pan/tilt head from one place to another or pick it up when
5 Tally lamp
This is lit by the tally ON signal of the hybrid controller or
other device. For further details, refer to the operating
instructions of the controller.
6 Rotary arm anchoring screws (supplied)
These hexagon head bolts (a8) are used to anchor the
Holes for attaching the pan/tilt head
These holes are used for anchoring the pan/tilt head
when it is installed.
Lens I/F connector (12-pin round)
This connector is used to control the zooming and
focusing of the motorized lens unit.
ND/EXT CONTROL connector
This output connector is used to perform ON/OFF control
for the motorized ND filter, the ND filter of a lens with a
built-in motorized extender and the lens extender. The
connector has contact outputs. The R03-P6M or R03-
PB6M connector made by Tajimi Electronics Co., Ltd. is
A : ND signal
B : ND return
C : EXT signal
D : EXT return
E : GND
F : VCC (+15 V)