Connection Cable; Confirmation Of Software Version - Panasonic AJ-RC10G Operating Instructions Manual

Connection cable

A 10 m connection cable is attached to the unit. To extend the cable, use the optional dedicated cable.
If several 10 m cables are connected in tandem, the power supply may be unstable due to voltage
drops etc.
In an emergency, apply a higher voltage within a range from 11 V to 17 V for the power supply of DC 12
V to the camera recorder. If the input voltage to the unit is 8 V or less, operation becomes unstable.
Refer to the following. A twisted-pair cable must be used for the control line of the 10-pin cable.
Attenuation of the coaxial cable must be set to around –6 dB at maximum in 10 MHz.
Camera recorder side
HR10A-10P-10P (Hirose Electric)
CAM DATA (H)
CAM DATA (C)
CAM CONT (H)
CAM CONT (L)
ECU_ON
Video output
GND (Video)
Standby
+12 V (IN)
GND
Connector GND

Confirmation of software version

The software version for this unit can be confirmed in "VERSION" under SYSTEM in the unit menu.
Confirm for questions.
1
Twisted pair
2
3
Twisted pair
4
5
6
7
8
3 h or less
9
3 h or less
10
1.5C - 2V
Controller side
HR10A-10P10S (Hirose Electric)
CAM DATA (H)
1
CAM DATA (C)
2
CAM CONT (H)
3
CAM CONT (L)
4
ECU_ON
5
Video input
6
GND (Video)
7
Standby
8
+12 V (IN)
9
GND
10
Connector GND
E-32