I Connections With Ps·data Systems - Panasonic WJ-HD309 Operating Instructions Manual

I Connections with PS·Data systems
This is an example of connection when the unit is used together with the PS·Data devices.
If a connected system controller is PS·Data compatible, it is possible to operate this unit or connected devices using the sys-
tem controller.
Use the RS485 cable provided with the system controller.
Important:
• Terminate both devices on both ends of the connection. Refer to the respective operating instructions for the descriptions
of how to terminate. Termination of this unit can be set with the mode switch on the rear panel. (See below.)
• When connecting a PS·Data compatible device, it is necessary to set each item of "PS·Data Setup" of "Comm" on the
SETUP MENU according to the system configuration.
• The PS·Data is our exclusive protocol. Contact the dealer about devices that can be connected.
G When connecting this unit with a controller
74
System Controller
RS485 cable (provided with the controller)
Controller
Termination: ON
Unit Address : 1
1
3 1
SERIAL
CASCADE
4 2 OUT
2
AUDIO IN AUDIO OUT
MONITOR OUT CASCADE IN MONITOR (VGA) ALARM/CONTOROL
16 15 14 13 12 11 10 9
IN
OUT
16 15 14 13 12 11 10 9
VIDEO
"PS·Data setup" of "Comm" on the SETUP MENU
• Unit Address (System)
• Unit Address (Controller) : 2
Mode switch
ON
1 2 3 4 5
MODE
COPY 1
ALARM
2 1
DATA RS485(CAMERA) 10/100BASE-T EXT STORAGE
8 7 6 5 4 3 2 1
8 7 6 5 4 3 2 1
: 1
(No. 7: ON)
(No. 8: OFF)
6 7 8
SIGNAL GND
POWER
AC IN