Basic Operation - Jvc Ra-E611B-Dab Instruction Manual

GETTING STARTED
POWER SOURCE
Mains Power
• Connecting the unit to any other power source may cause damage the unit. Unwind the
mains adapter cable to its full length. Connect the end of the cable to the DC IN socket at
the rear of the unit and then connect the mains adapter to the mains socket. Make sure the
mains adapter is firmly inserted into the mains socket. The unit is now ready to use.
• To switch the unit off completely, unplug the mains adapter from the mains socket.
Battery Power
Insert 4 x 1,5V AA batteries (not included) correctly by following the polarity (+ or –) indications
in the battery compartment.
NOTE: When the batteries become weak, the display will show <Battery Low>. The batteries should be
replaced. When the batteries are completely exhausted, the power is turned off.

BASIC OPERATION

Powering ON/OFF
After connecting the mains adapter to the unit and the mains socket, the unit will enter Standby
mode.
• Press the STANDBY button to switch on the unit.
• Press the STANDBY button again to switch the unit back to Standby mode.
• Disconnect the power cable of the mains adapter from the mains socket if you want to
switch the unit off completely.
Display Backlight (Mains Power only)
There are four backlight levels (High, Medium, Low, Off) to choose from. To set the backlight
level, repeatedly press the DIMMER/SNOOZE button and the brightness of the display will
change.
Volume
Rotate the VOLUME knob to adjust the volume.
Mode selection
Press MODE button button to select the desired source.
NOTE: DAB+ and FM stations will only be available separately when BestTune
PRESETS
You can store up to 30 of your favorite DAB or FM stations to the memory. This will enable you
to access your favorite stations quickly and easily. To store a preset, you must first be listening
to the station that you would like to save.
Storing to Presets 1-7
• Press and hold the PRESET 1-7 buttons.
• The words <Preset # saved> will show on the display.
Storing to Presets 1-30
• Press and hold the PRESET 8+ button, and then press the ▲ / ▼ buttons to select the
preset station number to save. Press the SELECT button to confirm selection.
• The words <Preset # saved> will show on the display.
Recalling Presets 1-7
Press the PRESET 1-7 buttons.
EN
is set to Off.
TM