Black & Decker BXFT50005GB Quick Start Manual page 8

ENGLISH (Original instructions)
Turning the Unit On or Off
♦
Plug the unit in to a mains power supply. Flick
the switch on the body of the machine to the ON
position.
♦
The appliance will emit an audible signal and enter
stand-by mode.
NOTE: In stand-by mode functions and respective
icons are inactive.
♦
Press the Power key on the control panel or on
the remote control to turn the unit ON. The LOW
Heating indicator will illuminate and, after a
few seconds, the room temperature will show in
the LED display.
NOTE: If the temperature is less than or equal to
10°C, 'LO' will be displayed. If the temperature is
40°C or above, 'HI' will be displayed.
NOTE: Once turned ON, the default setting of the
appliance is:
♦
Low heat
♦
Fan on
♦
Temperature setting at 25°C
♦
Oscillation function off
♦
Timer off
♦
Press the Power key to turn the unit to stand-
by mode. To turn the unit OFF, flick the switch on
the body of the machine to the OFF position.
NOTE: If the Timer has not been set the unit will turn
off automatically after 12 hours continuous operation
(starting from the last press of the control panel or
remote control).
Heat Setting Selection
♦
Once the unit has been turned ON, press the Heat
Setting key to cycle between LOW and HIGH
heating settings.
♦
The corresponding indicators will illuminate to
confirm the option selected:
LOW or HIGH .
NOTE: It may take approximately 10 seconds for the
higher heat mode to activate.
8
Cool Fan Setting
♦
Once the unit has been turned ON, press the Fan
Speed key to cycle between LOW and HIGH
fan speed.
♦
The corresponding indicators will illuminate to
confirm the option selected:
LOW or HIGH .
NOTE: Note: If the Heat Setting
selected then the Fan setting
Likewise, if the Fan setting
then the Heat setting will turn off.
Temperature Selection
♦
Once the unit has been turned ON, press the
Temperature key to change the temperature
required in the range of 15°C -35°C. The display
will flash.
♦
On the control panel, press the
the temperature and the
temperature. The temperature will change in
increments of 1°C. Press and hold the keys to
rapidly change the temperature. Alternatively use
the remote control Temperature button.
♦
Press the Temperature key
the setting or, if there is no further change
made within 5 seconds the Temperature will
automatically set. The display screen will show
the room temperature and the '°' icon will remain
illuminated to show the Temperature has been set.
♦
Follow this process to change the temperature set
at any point during operation.
♦
Press the Temperature key
operation to check the temperature set.
♦
Once the unit has detected the ambient
temperature and compared it to the set
temperature, if the temperature of the room is
greater than the set temperature the heating
will turn off automatically. The LOW/HIGH heat
indicator light will go off, the fan will stop after
10 seconds and, if activated, the unit will stop
oscillating.
♦
Once the ambient temperature drops 1°C below
the set temperature, the heating function will
restart together with the fan and the oscillation
function, if previously activated. Corresponding
icons will illuminate.
NOTE: If the Timer and Temperature are both set
then the time and room temperature will alternate in
the display every 30 seconds.
has been
will turn off.
has been selected
key to increase
key to decrease the
to confirm
at any point during