Conair CS45 Instruction & Styling Manual

IMPORTANT SAFETY
4. Use this appliance only for its intended use,
as described in this manual. Do not use attach-
INSTRUCTIONS
ments not recommended by the manufacturer.
5. Never operate this appliance if it has a
When using electrical appliances, especially
damaged cord or plug, if it is not working
when children are present, basic safety pre-
properly or if it has been dropped or damaged,
cautions should always be followed, including
or dropped into water. Return the appliance to
the following:
an authorized service center for examination
READ ALL INSTRUCTIONS and repair.
6. Keep the cord away from heated surfaces.
BEFORE USING
7. Never use while sleeping.
8. Never drop or insert any object into any
KEEP AWAY FROM WATER
opening.
9. Do not use outdoors or operate where
DANGER
- aerosol (spray) products are being used or
Any appliance is electrically
where oxygen is being administered.
live even when the switch is off. To reduce
10. Unit is hot when in use. Do not let heated
the risk of death by electric shock:
surface touch eyes or bare skin.
1. Always unplug appliance immediately after
11. Do not place the heated unit directly on
using.
any surface while it is hot or plugged in.
2. Do not use while bathing or in the shower.
12. Never block the air openings of the appli-
3. Do not place or store appliance where it
ance or place on a soft surface such as a bed
can fall or be pulled into a tub or sink.
or couch, where the air openings may be
4. Do not place in, or drop into, water or other
blocked. Keep the air opening free of lint and
liquid.
other debris.
5. If an appliance falls into water, unplug it
13. Do not use an extension cord with this
immediately. Do not reach into the water.
appliance.
Warning
14. Do not touch hot surfaces of the appli-
-
To reduce the risk of
ance. Use handles or knobs.
burns, electrocution, fire, or injury to persons:
15. Do not attempt to touch the housing of
1. This appliance should never be left your appliance near the straightening plates,
unattended when plugged in. as it is hot when in use.
2. Do not pull, twist, or wrap line cord around
SAVE THESE
appliance.
3. This appliance should not be used by, on
INSTRUCTIONS
or near children or individuals with certain
disabilities.
OPERATING
WARNING: The straightening iron's nano
silver tourmaline ceramic-coated plates
INSTRUCTIONS
will get very hot within a few seconds
and should not be placed in contact with
This straightening iron is intended for house- the skin after the straightening iron has
been turned on.
hold use. Use on Alternating Current (60 hertz)
only. This unit is designed to be operated at
120 volts AC.

Temperature Setting Guide

This appliance has a polarized plug (one blade
LED TEMP. CONTROL
is wider than the other). As a safety feature,
this plug will fit in a polarized outlet only one
Power/Low 285ºF-310ºF Delicate, thin, easy-to-straighten hair
way. If the plug does not fit fully in the outlet,
Medium 330ºF
reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to defeat
Med-High 360ºF
this safety feature.
High/Max 395ºF
TO STRAIGHTEN HAIR
Hair should be clean and completely dried
before using the straightening iron. Plug the
iron into an electrical outlet. Turn on unit. The
Power/Low 285 º F and Ion On settings will
become illuminated.
To turn off, press Off button (lights will go off).
Never leave your straightening iron on and
unattended. However, should you fail to turn
the unit off it will shut itself off automatically
within 60 minutes.
INSTANT HEAT TECHNOLOGY
The iron's unique high temperature settings and
Instant Heat technology provide styling versatil-
ity for all hair types. If you have fine hair, a low
temperature will provide the best results. If you
have thick, wavy or hard-to-straighten hair,
keep the heat setting on high. You can vary the
iron's temperature according to your particular
need by scrolling the
HAIR TYPE
temperature settings using the +/– buttons.
For best results, use a light styling product
before blow-drying hair. Start with a hair
Average-to-thick or treated hair
section that is 1 ½" wide and no more than
Thick or wavy hair
½" thick. Open the iron and place a hair
section between the two hot plates, close
Hard-to-straighten hair
to the scalp. Trap hair between the plates by
firmly squeezing the handles together. While
maintaining the tension, slowly pull the unit
down along the hair section toward the end
of hair. At the end of hair section, release
the pressure on the handle and allow the
hair section to slide out. Repeat process on
additional sections of hair until you achieve
the hair style you desire. It may be necessary
to repeat process on certain areas, depending
on the texture of your hair.
As you straighten your hair, you'll find that
it glides more easily over the micro-bonded
plate surfaces, and any residue from styling
products is easy to remove.
Some experience is necessary when learning
to use this straightening iron. After using the
iron several times, you will learn the ideal
way to straighten and style your hair.
STYLING WITH THE NANO SILVER USING INSTANT HEAT, THE 5 ULTRA-
TOURMALINE CERAMIC ™ COATED PLATES HIGH HEAT TEMPERATURE SETTINGS
& UNIFORM HEAT RECOVERY SYSTEM
Your new straightening iron features nano
technology – micro particles that create This styling iron features a ceramic heater
that maintains high temperatures during use
stronger bonds to plate surfaces, for smoother
glide, maximum manageability and more for precision styling. It heats up quickly to the
temperature you've selected for your hair type.
professional results.
NANO SILVER TECHNOLOGY combines the This Instant Heat technology has 5 ultra-high
technology of micro particles of ceramic temperature settings. There is a temperature
and silver for clean, beautiful, healthy range that's gentle and safe for every type of
looking results. hair, from the finest to the curliest and most
resistant, and helps you create the look you
The Nano Silver Tourmaline Ceramic™
want. And that's not all. Conair's professional
Technology combines all that is best for your
salon standards of engineering provide you
hair. Nano silver's unique properties leave
with a uniform and improved heat recovery
hair cleaner, shinier and healthier looking.
system that maintains the iron at constant
Tourmaline emits infrared heat for gentle styl-
temperatures. There is a constant surge of
ing, and natural ions that reduce frizz, help
power to ensure that heat is continuously and
smooth down flyaways and renew the vitality
quickly delivered for optimal styling results,
of your hair. And ceramic generates gentle
unlike other units, which lose heat during
infrared energy and evenly distributes heat to
use. This provides consistent styling power so
protect hair from damage. Whatever style you
that every strand of your hair is set with the
create, this trio of technologies leaves your
same level of heat and comes out the same
hair with a salon-perfect, silky smooth finish.
way for a perfect finish.
THE IONIZING FUNCTION generates a cloud of
negative ions that can:
• neutralize the generally positive charge on
flyaway, frizzy hair
• eliminate static electricity
• contribute to shine
The new Nano Silver Tourmaline Ceramic™
Technology makes this straightener a pleasure
to use – styling has never been easier! Get
ready to experience salon results without
the salon!