Paper Feed Settings
∫ Selecting the paper path for scanned document
To select a U-turn path pass through to the
front, set the paper path selector to the
upper side.
To select a straight path pass through to the
back, set the paper path selector to the
lower side.
≥ When scanning documents with a thickness of
0.2 mm to 1 mm, like folded documents, set the
paper path selector to straight path.
∫ Setting the ADF / manual feed selector
¥ Single scanning
When scanning a single sheet or several
sheets, set the ADF / manual feed
selector to "MANUAL".
¥ Continuous scanning
Setting
Position
When double feeding occurs
frequently
1
document with a rough face as
in NCR paper
2
(Standard
When scanning normal paper
setting)
When scanning with smooth
3
sided paper or a paper jam
occurs with normal paper
When a jam occurs at the
4
paper feed component
≥ The ADF / manual feed selector must be set
in the correct position for this setting to
function properly.
≥ If double feed alarm beeps frequently,
change the ADF / manual feed selector.
Status
or
scanning
a
The paper path selector is located on the left
side of the scanner.
ADF ADJ.
1
2
3
MANUAL
4
ADF / manual feed selector
The ADF / manual feed selector is located on
the left side of the scanner.
≥ If thin paper (with paper weight less than 50 g/m
causes a paper jam frequently at the paper feed
component, the optional roller exchange kit for thin
paper (KV-SS018) should be used.
Paper path selector
2
)
17