Feature Operations
Making Calls
This section explains the basic methods for making a
call.
Making a Call
1.
In stand-by mode, go off-hook.
2.
Enter the number you want to call.
3.
Press [ENTER], or wait a few seconds for the
number to be dialed.
4.
To end the call, go on-hook.
Note
•
For KX-UT113/KX-UT123, if more than one line
is available at your unit, you can press
before going off-hook and then select the line
you want to use.
Pre-dialing
In stand-by mode, you can start dialing (max. 32 digits)
while still on-hook.
•
To delete a number you entered, press
•
To clear the entire number, press and hold
•
To connect the call, go off-hook or press [ENTER].
Note
•
For KX-UT133/KX-UT136, you can also press
an idle DN button (flexible button) to connect the
call. For details about DN buttons, see "Flexible
Buttons (KX-UT133/KX-UT136 only)
(Page 34)".
•
For KX-UT113/KX-UT123, when pre-dialing
you can press
If more than one line is available at your unit,
select the line to use, and then press [ENTER].
•
If you receive an incoming call during
pre-dialing, the display changes to the incoming
call screen. For KX-UT133/KX-UT136, you can
close the incoming call screen by pressing
, and continue pre-dialing.
Close
Document Version 2011-09
Clear
instead of going off-hook.
Call
Making a Call from the
Phonebook List
Scrolling through all entries
1.
Press
2.
Press [ ] or [ ] to select an entry.
3.
Go off-hook.
4.
To end the call, go on-hook.
Note
•
For KX-UT133/KX-UT136, you can also press
an idle DN button (flexible button) in step 3 to
connect the call. For details about DN buttons,
see "Flexible Buttons (KX-UT133/KX-UT136
only) (Page 34)".
•
For KX-UT113/KX-UT123, you can press
Call
one line is available at your unit, select the line
to use, and then press [ENTER].
Line
•
In step 2, if multiple phone numbers are stored
for the entry, you can press
select the phone number to call.
Searching by name
1.
Press
.
2.
Press
Search
3.
Enter the name (max. 12 characters) you want to
.
Clear
search for.
4.
Press [ENTER].
The entry that matches your search appears.
5.
Go off-hook.
6.
To end the call, go on-hook.
Note
•
For KX-UT113/KX-UT123, you can press
Call
one line is available at your unit, select the line
to use, and then press [ENTER].
•
For details about entering characters, see
"Entering Characters (Page 48)".
•
In step 4, if multiple phone numbers are stored
for the entry, you can press
select the phone number to call.
•
If you do not press any buttons for 1 minute, the
unit will return to stand-by mode.
Feature Operations
.
instead of going off-hook. If more than
Number
.
.
instead of going off-hook. If more than
Number
Operating Instructions
and then
and then
25