Date and Time
We recommend you set the date and time so that the unit will announce the day
and time each message was recorded when you play back messages.
1
Press [MENU].
2
Scroll to "Date and time" by pressing [d]
or [B], then press the soft key (
3
(1) Enter 2 digits each for the month, day and
year. (Ex. To set June 15, 2005, enter
"06 15 05".)
(2) Enter 4 digits for the time (hour and
minute). (Ex. To set 9:30, enter "0930".)
• If you enter a wrong number, press the soft key
(
) or (
f
g
move the cursor to the incorrect number. Enter
the correct number.
4
Select "AM" or "PM" by pressing [*].
5
Press the soft key (
• The date and time are set and "
• If the handset beeps 3 times, the date and time were not set correctly. Start
again from step 3.
6
Press [OFF].
• When entering the time, you cannot enter numbers greater than 12. Do not use
military time. (To set 13:00 hours, enter "0100", and select "PM" in step 4.
The date and time may be incorrect after a power failure. When "
the base unit display, set the date and time again.
To confirm the date and time, repeat steps 1 and 2.
• The current date and time are displayed. When finished, press [OFF].
For Caller ID service users (p. 40)
• When a call is received, Caller ID information adjusts the date and time if the
time is incorrect.
• Caller ID information will automatically adjust the date and time for daylight
saving time.
• If the date and time have not been previously set, Caller ID information will not
adjust the date and time.
For assistance, please call: 1-800-211-PANA(7262)
Programmable Settings
Handset
SELECT
), or press [B] or [d] to
).
SAVE
E
" disappears from the base unit display.
B
).
Date and time
d
BACK
P LAY
Date:|
1 2.31.2004
Time:12:00 AM
0-9=Date&Time
@=AM/PM
f
Date:|
0 6.15.2005
Time:09:30 AM
0-9=Date&Time
@=AM/PM
f
E
SELECT
g
SAVE
g
SAVE
)
" flashes on
19