Troubleshooting - Panasonic KX-TG2214F Operating Instructions Manual

Troubleshooting

Problem
The unit does not work.
"No link to base.
Place on cradle and
try again." is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset does not ring.
The handset display is
blank.
You cannot program
function items.
While programming or
searching, the unit starts to
ring and stops the
program/search.
40
Cause & Remedy
• Check the settings (p. 8–9).
• Check whether the dialing mode setting is
correct (p. 12).
• Charge the battery fully (p. 8).
• Clean the charge contacts and charge again
(p. 9).
• Install the battery properly (p. 8).
• Place the handset on the base unit and unplug
the AC adaptor to reset it. Plug in, and try again.
• Re-install the battery (p. 8) and charge it fully.
• You are too far from the base unit. Walk closer
and try again.
• Place the handset on the base unit and try
again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
• Move the handset and the base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 18).
• The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 15).
• Charge the battery fully (p. 8).
• Programming is not possible while the unit is
being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• A call is coming in. To answer the call, press
[ ] or [ ]. Start again from the beginning after
hanging up.