Installation Of Wired Controller - Pioneer ADSA1 Manual

Wired controller
Table of Contents

Advertisement

Installation

3. Installation of Wired Controller

The simple installation step of wired controller is as shown on the figure, please notice below
issues:
● Open the bottom plate of the wired controller.
● Pull out the 4 core twisted pair wire from the mounting hole and pass this line through the
square hole located at the bottom plate of the wired controller.
Use M4×25 screws to fix the bottom plate together with installation hole of the wall.
● Insert the through signal wire in the slot on the wired controller, also lock the wired
controller panel and bottom plate together.
2

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

Table of Contents