40
Care and Cleaning
Aluminum Foil, Aluminum utensils, and
Oven Liners
WArNING
Never cover any slots, holes, or passages in the
oven bottom or cover an entire oven rack with
materials such as aluminum foil . Doing so blocks
air flow through the oven and may cause carbon
monoxide poisoning . Aluminum foil linings may
trap heat, causing a fire hazard .
•
Protective liners—Do not use aluminum foil to
line the oven bottom . The high heat of the oven
can melt these materials to the oven cavity and
ruin the oven . These types of materials can also
reduce the effectiveness of the air circulation
in the oven and produce poor baking results .
Only use aluminum foil as recommended in this
manual . Improper installation of these liners
may result in risk of electric shock or fire .
•
Aluminum utensils - The melting point of alu-
minum is much lower than that of other metals .
Care must be taken when aluminum pots or
pans are used .
•
Oven racks - Do not use aluminum foil to
cover the oven racks . Using a liner in the oven
restricts the heat and air flow needed to obtain
the best possible cooking results for any oven .
cAutION
Do not to use harsh abrasives on the glass panes
as the reflective surface plays a role in the function
of the oven . Do not place glass in dishwasher .
Hand wash only with a soft cloth and warm soapy
water . When dry polish with a soft cloth and
ensure the glass is dry before reassembly .
replacing the Oven Light
cAutION
Be sure the oven is unplugged and all parts are
cool before replacing the oven light .
The interior oven light is located at the rear of the
oven cavity and is covered by a glass shield . The
glass shield must be in place whenever the oven is
in use .
To replace the oven interior light bulb:
1 .
Turn electrical power off at the main source or
unplug the appliance .
2 . Remove interior oven light shield by turning a
quarter turn counter-clockwise .
3 . Replace bulb with a new T-4 type Halogen 25
watt appliance bulb .
NOtE
Wear a cotton glove or use a paper towel when
installing a new bulb . Do not touch the new bulb
with your fingers when replacing . This will short-
en the life of the bulb .
4 . Replace glass oven light shield by rotating
clockwise .
5 . Turn power back on again at the main source
(or plug the appliance back in) .
6 . Be sure to reset the time of day on the clock .
Figure 13: Wall oven Halogen light