Graf oneAdvanced Operation Manual page 63

8. Service menu for authorised specialist
NOTE
Each cycle phase and each work step also shows the outputs used. Example: "Charging: X31,
X16.V1" signals that, for charging purposes, output X31 for the compressor and X16.V1 for
valve 1 are being addressed. Edits are possible in the menu "Assign outputs".
NOTE
The T-settings may be edited in steps of one minute. Steps of 0.10 min are also possible for
subminute durations. The setting 0.00 min means that the T step is not activated.
63 / 137