GETTING STARTED
BATTERIES
Batteries are not supplied with this product. You will need
to purchase 3 x UM-3 (AA) 1.5V alkaline batteries for
the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries
for the remote sensor.
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
Do not use rechargeable batteries.
NOTE
shows when batteries are low.
UNIT
Main
Remote
BAR618HGA lab test R4
LOCATION
Indoor Temperature /
Humidity Area
Outdoor Temperature /
Humidity Area
6
6
CHANGE SETTINGS
1.
Press and hold MODE for 2 seconds to enter setting
mode.
2.
Press UP or DOWN to change settings.
3.
Press MODE to confirm.
TABLE STAND OR WALL MOUNT
Use the stand on the back of the product, or mount it on
a wall with a nail.
REMOTE SENSOR (THGR122NX)
This product is shipped with a THGR122NX Thermo/
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.
SETUP SENSOR
1.
Open the remote sensor battery compartment with
a small Phillips screwdriver.
2.
Insert the batteries, matching the polarity as shown
in the battery compartment.
3.
Set the channel. The switch is located in the battery
compartment.
SWITCH
OPTION
Channel
Channel 1 - 3. If you are using
more than one sensor, select a
different channel for each sensor.
2/18/04, 11:26 AM