Nct5525D Hw Monitor - DFI EHL556 User Manual

► Advanced

NCT5525D HW Monitor

Aptio Setup - AMI
Advanced
Pc Health Status
Smart Fan Function
X
System temperature : +37 oC
CPU temperature : +33 oC
SYS_Fan Speed : N/A
VBAT : +3.040 V
VCORE : +0.896 V
5V : +5.200 V
3V3SB : +3.116 V
3V3 : +3.144 V
Version 2.22.1282. Copyright (C) 2022 AMI
User's Manual | EHL556
► Advanced
► Smart Fan Function
Smart Fan function setting
PC Health Status
System Smart Fan Control
System Smart Fan Mode
Boundary 1
Boundary 2
Boundary 3
Boundary 4
Speed Count 1
Speed Count 2
Speed Count 3
Speed Count 4
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Smart Fan is a fan speed moderation strategy dependent on the current system temperature.
When the system temperature goes higher than the Boundary setting, the fan speed will be
turned up to the setting of the Fan Speed Count that bears the same index as the Boundary
field.
▼ SYS Smart Fan Control
Boundary 1 to Boundary 4
Set the boundary temperatures that determine the fan speeds accordingly, the value ranging
from 0-127℃. For example, when the system temperature reaches Boundary 1 setting, the
fan speed will be turned up to the designated speed of the Fan Speed Count 1 field.
Fan Speed Count 1 to Fan Speed Count 4
Set the fan speed, the value ranging from 1-100%, 100% being full speed. The fans will oper-
ate according to the specified boundary temperatures above-mentioned.
▼ SYS Smart Fan/CPU Smart Fan Control = [Disabled]
Fix Fan Speed Count
Set the fan speed, the value ranging from 1-100%, 100% being full speed. The fans will al-
ways operate at the specified speed regardless of gauged temperatures.
► NCT6126D HW Monitor
Aptio Setup - AMI
Advanced
[SMART FAN IV]
[30]
[40]
[50]
[60]
[35]
[60]
[80]
[100]
Version 2.22.1282. Copyright (C) 2022 AMI
Chapter 3
BIOS SETTINGS
Enable CPU SmartFan
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
32