Zooming And Aspect Ratio Control; Zoom Levels For Hdmi 1 Output - Oppo BDP-93 User Manual

A D V A N C E D O P E R A T I O N S
The following output resolutions are available:
NTSC output via HDMI 1 or HDMI 2:
PAL output via HDMI 1 or HDMI 2:
NTSC output via Analog (component):
PAL output via Analog (component):
* When 1080p is selected for the Analog output, the actual component output resolution will be 1080i.
NOTE

Some TV sets do not support one or more output resolutions (particularly 1080p). If
an incompatible output resolution is selected, you will get a blank screen or an error
message. In this case please select an output resolution that is supported by the TV.

If you cannot get a picture using the HDMI or component output, please connect the
player to the TV using the composite video output, then use the Setup Menu to adjust
the player settings.

Video up-conversion over the component output is only available for unencrypted
discs such as home video and consumer-created contents.
pressed DVD discs are CSS-encrypted and will be limited to 480i/480p resolution.
This restriction applies to the component output only. The HDMI output is protected
with HDCP and has no such restriction.

Zooming and Aspect Ratio Control

ZOOM

Zoom Levels for HDMI 1 Output

The following zoom levels are available when "Primary Output" is set to "HDMI 1":
 Under Scan  1.2  1.3 1.5  2.0  ½ Back to 1:1 again
Auto  1080p(60Hz/24Hz)  1080i 60Hz  720p 60Hz
 480p  480i  Source Direct
Auto  1080p(50Hz/24Hz)  1080i 50Hz  720p 50Hz
 576p  576i  Source Direct
1080p 60Hz*  1080i 60Hz  720p 60Hz  480p  480i
1080p 50Hz*  1080i 50Hz  720p 50Hz  576p  576i
This feature zooms in or out of the displayed frame and also changes the
aspect ratio (image width vs. height).
To change the zoom level, press the ZOOM button on the remote control.
Each press of the ZOOM button will switch the zoom level in sequence.
1:1 (No zooming)  Stretch/Compress  Full Screen
34
Most commercially
DVD-A