Wiring And Sequence Of Operation - Haier GE NF80XV Series Service Manual

80% two stage variable speed ultra low nox gas furnace
Table of Contents

Advertisement

Air Fuel Plenum
Gasket
Burner
Gasket

Wiring and Sequence of Operation

NOTE: The ignition control thermostat selection DIP switch
is factory-set in the "TWO-STAGE" position.
WARNING
Electric Shock Hazard. Can cause injury or
death. Unit must be properly grounded in
accordance with national and local codes.re
attempting to service motor. Failure to wait
may cause personal injury or death.
WARNING
Fire Hazard. Use of aluminum wire with this product
may result in a fire, causing property damage, severe
injury or death. Use copper wire only with this product.
Heat Exchanger and Burner Assembly Removal
* Re-install screws per the numbered sequence shown
*Air Fuel Plenum
Gas Valve
Debri Screen
Air Intake Assembly
Figure 21.
Page 34
Heat Exchanger
Gasket
(replace)
CAUTION
Failure to use properly sized wiring and circuit breaker
may result in property damage. Size wiring and circuit
breaker(s) per Product Specifications and unit rating
plate.
31-5000734 Rev. 0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GE NF80XV Series and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Ge nf80x060v3aGe nf80x080v4bGe nf80x100v5c

Table of Contents