Changing Volume Lock; Troubleshooting; Fcc Compliance - One for All URC-10820 User Manual

OFA 10L with Learning Owners Manual.fm Page 18 Thursday, January 27, 2005 1:34 PM
O F A 10L U
NE OR LL NIVERSAL
PROBLEM: Changing channels does
not work properly.
SOLUTION: If the original remote
control required pressing
ENTER to change channels,
then press ENTER on the
remote control after
entering the channel
number.
PROBLEM: During learning, LED
emits a long blink after
pressing and holding key
to be learned.
SOLUTION: Memory is full or a bad
capture has occurred.
Avoid high-ambient light
sources, such as direct
daylight and fluorescent
bulbs. Try readjusting
positions of remote
controls before performing
the procedure again.
PROBLEM: Tried Searching For Your
Code method and still
could not find a working
code.
SOLUTION: Clear the device key as
follows: Press and hold SET
until the LED (red light)
blinks twice, then
release.Next enter 9 9 2.
Then press the device key
to be cleared twice.Now
repeat the Searching for
Your Code method on page
9.
PROBLEM: CH+ and CH- do not work
for your RCA TV.

18 FCC Compliance

R C L
EMOTE ONTROL WITH EARNING
SOLUTION: Due to RCA design (1983-
1987), only the original
remote control will operate
these functions.
PROBLEM: No remote control of
volume.
SOLUTION: See "Changing Volume
Lock" on page 15 to lock/
unlock volume.
PROBLEM: If the above does not work.
SOLUTION: Please contact us in any of
the following ways:
• Please visit:
• If the above website is
• Customer Support:
FCC COMPLIANCE
This equipment has been tested and found
to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide a
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiated radio frequency energy and if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
www.oneforall.com
not able to provide you
with the information
you need, please email
us at
ofasupport@ueic.com
and refer to

"Troubleshooting"

(330) 405-8516
Mon- Fri from 9AM to
5PM ET