Dip Switches - Epson FX-80 User Manual

*
2K buffer available for user-defined characters
* Paper-out sensor on
l
*
Non-slashed zero (although there's no code for "turning on"
slashed zero, you can slash one zero at a time with backspace)
*
Carriage return issued at the end of a line without an automatic
line feed
Bidirectional movement of the print head
l
* Skip-over-perforation feature off
l
*
Beeper on (turning off the paper-out sensor deactivates the
beeper for this function but not for others)
Top of form occurs at the position of the print head when you
reset the printer-by turning power on or by issuing an ESCape
"@"-or when you change the form length with either format of
ESCape "C".

DIP Switches

The FX printers have two sets of internal switches which are used by
the printer to determine the default mode on power-up. The switches
are under the upper right vent. As outlined in Chapter
screw must be removed with a Phillips-head screwdriver in order to
take the cover off.
Since switch settings are only checked by the printer on power-up,
all switch setting should be done with the power off. The printer will
not recognize changes made in switch settings when the power is on
until the printer is turned off and then on again.
The factory sets and numbers the switches in the following way:
296
the vent
1,