Epson PictureMate Start Here Manual page 2

3
Move the lever to the Release position by sliding it
in the direction shown.
4
Shake the photo cartridge
a few times in its package,
then unwrap the cartridge.
5
Slide the cartridge straight into the slot, label side up,
until it is fully inserted. Push in both sides evenly to
make sure it is not crooked.
Caution:
or ink may leak. If either side is sticking out, remove the
cartridge and reinstall it.
6
Move the lever right to the Lock position. If it does
not lock in place, the cartridge is not installed
correctly. Release it and try again.
7
Close the cartridge door. Make sure it is completely
closed.
If the door does not close completely, the cartridge is
not installed correctly. Remove it and try again.
8
Flip the handle to the
back of PictureMate
and all the way down.
Make sure both sides of the cartridge are even,
Right
To release lever
Wrong