HP Compaq Presario CQ71 Maintenance And Service Manual page 65

4. Use the 2 Mylar tabs to slide the hard drive (2) to the right until it disconnects from the system
board.
5. Use the 2 Mylar tabs to lift the hard drive straight up (3), and remove it from the hard drive bay.
6. If it is necessary to replace the hard drive bracket, remove the four Phillips PM3.0×4.0 screws
(1) that secure the hard drive bracket to the hard drive.
7. Lift the bracket (2) straight up to remove it from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
Component replacement procedures 57