Print Quality Problems - Epson Stylus Photo RX600 User Manual

If paper jams frequently, make sure the left edge guide isn't pushed too tightly
against the paper. Also, try loading fewer sheets of paper. The stack should
never be above the arrow on the inside of the left edge guide. Some paper
types require that you load sheets individually, or you use a support sheet;
follow the instructions that came with your paper for specific instructions.
If paper jams frequently, you may also have pushed the paper down too far
into the paper path. Turn the Stylus Photo RX600 off and carefully remove
the paper. Then follow the instructions under "Loading Single Sheets" on
page 15 to reload the paper.
Paper doesn't eject fully or is wrinkled.
If the paper doesn't eject fully, you may have set the wrong paper size. Press the
button on the control panel to eject the paper, then select the
Load/Eject
correct paper size in your software.
If it's wrinkled when it ejects, the paper may be damp or too thin. Load new
paper.

Print Quality Problems

You see banding (light lines) in your printouts or copies.
Clean the print head; see page 129 for instructions.
Select the correct Type (Windows) or Media Type (Macintosh) setting for the
paper you loaded; see "Loading Special Papers" on page 19. If you're copying
without a computer, make sure you selected the correct paper type; see
"Selecting the Correct Paper Type" on page 91.
Problems and Solutions
147