Install Framing For Hood Support; Mounting The Hood - Electrolux RH30WC60GS Installation, Use & Care Manual

10
Installing the hood

Install framing for hood support

Install framing for hood support Install framing for hood support
Install framing for hood support Install framing for hood support
If drywall is present, mark the screw hole
locations. Remove the template.
Cut away enough drywall to expose 2 vertical
studs at the holes location indicated by the
template.
Install two horizontal supports at least ùé X 2é
between two wall studs at the bottom and upper
mounting holes installation location.
room side of the studs.
Use cleats behind both sides of the support to
secure to wall studs.
IMPOR IMPOR T T ANT - - - - - Framing must be capable of ANT ANT
IMPOR IMPOR IMPORT T TANT ANT
supporting êûû lbs. supporting êûû lbs. supporting êûû lbs. supporting êûû lbs. supporting êûû lbs.
Framing must be capable of Framing must be capable of
Framing must be capable of Framing must be capable of

Mounting the hood

Mounting the hood Mounting the hood Mounting the hood Mounting the hood
WARNING: 2 people are required to lift and position
the hood onto the mounting screws.
Place the template on the wall along the horizon-
tal line, make sure the template is leveled and
centered with the centerline.
Mark "upper" screw holes locations in the wall.
IMPORTANT. Check to be sure that hole locations
are leveled and correctly centered by the vertical
centerline.
Drive "upper" wood screws by hand. Leave ¼ " of
distance between the screw head and the wall.
onto the "upper" screws.
Mark "lower" wood screw holes locations in the
wall using a pencil.