Electrolux EWMED70JIW Use And Care Manual page 26

Operating User Interface Features
26
Setting Preferences, continued
INSTALL CYCLE
Run the INSTALL CYCLE before operating the dryer
the fi rst time. Remove all items from the dryer drum
and press start. For more information on performing
the dryer INSTALL CYCLE, refer to the Installation
Instructions accompanying this dryer.
If the dryer has been installed according to Installa-
tion Instructions,
and the dryer is ready to use.
If the dryer was not installed properly,
CORD NO GAS
,
will be displayed to indicate the installation error.
The errors may result from the following conditions:
• SERVICE CORD
ply cord has been installed improperly or the house
wiring to the receptacle is incorrect.
• NO GAS
the dryer and the gas line or the valve is closed.
• CALL SERVICE
calling a qualifi ed technician (1-877-435-3287).
Repeat the INSTALL CYCLE when corrections are
completed.
RESET
Press the buttons indicated to restore only cycle set-
tings, reset only factory preferences (users, language,
brightness, volume, etc.) or restore all factory defaults
(both cycle settings and factory preferences). Press
the button under EXIT to return to normal opera-
tion or press the cancel button to turn the dryer off
without making any changes. If you do not make a
selection within 30 seconds the dryer will return to
normal operation without any changes. If you reset
all settings, INSTALL CYCLE will be displayed as
though the dryer were just turned on for the fi rst time.
You may press the button under CANCEL if you do
not wish to rerun the INSTALL CYCLE.
CONTRAST
Press the button beneath plus (+) or minus (-) sym-
bols to increase or decrease the contrast of the
display. Press select to accept the change or press
the button under EXIT to return to normal operation
without any changes.
INSTALL PASS!
CALL SERVICE 877 435 3287
or
(electric dryer)—The power sup-
(gas dryer)—There is no connection between
—Error can only be corrected by
The INSTALL CYCLE is prompted automatically
only once when the dryer is turned on the
fi rst time at the end of installation. After that,
if you wish to run a subsequent INSTALL
CYCLE when moving the dryer or modifying
your installation, you may perform your own
INSTALL CYCLE by selecting it in the set prefs
will be displayed
feature and then following the screen prompts.
SERVICE
NOTE