Step 1 — Obtain Cut-Out Dimensions; Step 2 — Cut The Surface - Extron electronics TLP Pro 320C Setup Manual

Step 1 — Obtain Cut-Out Dimensions
ATTENTION:
• The opening in the table for the Cable Cubby should be cut only by licensed and bonded craftspeople. Exercise care
to prevent scarring or damaging the furniture.
• L'ouverture dans la table pour le Cable Cubby devrait être coupée seulement par des artisans autorisés et qualifiés.
Faites attention à ne pas faire de marques sur le meuble et à ne pas l'endommager.
• Use the appropriate metal Extron routing template or refer to the surface cutout dimensions before cutting a hole in
the furniture or other surface. Pay special attention to the direction the unit will face. The connector access side is
Using a CNC wood
underlined (see
• Utilisez le gabarit de détourage métallique approprié ou reportez-vous aux dimensions de découpe de la surface
indiquées ci-après avant de découper le meuble ou la surface. Faites particulièrement attention à la directions dans
laquelle l'unité sera dirigée. Le côté pour accéder au connecteurs est souligné (voir
Extron ne sera pas responsable des erreurs de coupe.
• Ensure the table surface is at least 0.375 inch (0.95 cm) thick.
• Assurez vous que la surface de la table est au moins 0,95 cm (0,375 pouce) d'épaisseur.
If using a hand router, you should purchase the Extron TLP Pro 320C routing template.
If using a CNC wood router, use the exact cut-out dimensions (see
If using a reciprocating saw or jigsaw, use the paper cut-out template (available under the
page at www.extron.com).
Step 2 — Cut the Surface
CAUTION:
Risk of personal injury: Wear safety glasses when operating power equipment.
ATTENTION:
Risque de blessure: Portez des lunettes de sécurité lorsque vous utilisez l'équipement électrique.
Ensure the cut is laid out in exactly the desired location and the edge that opens on the lid is correctly oriented. After verifying and
checking dimensions, cut a hole in the surface of the furniture where the enclosure will be installed (see "Preparing the Table" in
the TLP Pro 320C User Guide). There are three methods for cutting the hole in the table:
Using a hand router
Recommended method — Use the Extron TLP Pro 320C
routing template. Refer to the Routing Template User Guide,
available at www.extron.com, to prepare the template and
use the template to cut the hole.
NOTE:
Purchase the metal router guide separately. Do
not discard it when the installation is complete as it is
reusable.
Using a CNC wood cutter
Recommended method — Use the exact cut-out dimensions:
7.50 +0.00/-0.02 inches W x 6.00 +0.00/-0.02 inches D
19.05 +0.00/-0.05 cm W x 15.24 +0.00/-0.05 cm D
NOTE:
The underlined dimension is the connector or AAP
access side for the unit.
Using a reciprocating saw or jigsaw
Acceptable method — Use the paper cut-out template (available
under the tab on the TLP Pro 320C page at
Downloads
www.extron.com).
cutter). Extron is not responsible for miscut mounting holes.
Using a CNC wood
Product Category
Using a CNC wood cutter).
cutter).
tab on the TLP Pro 320C
Downloads
3