NorthStar 951X Operator's Manual page 87

951/952 Operator's Manual Rev. B
from lat/lon, loran TDs, or distance and bearing coordi-
nates.
For loran TDs, enter any legitimate pair of TDs and the
GRI for the pair. After entering the GRI, check the name of
the GRI which is automatically displayed, to be sure it's
correct.
For distance and bearing, enter the distance and bearing
from your present position, leave the FROM point set to
"HERE," and enter the bearing and the distance to the
desired waypoint. To enter distance and bearing from any
other waypoint stored in the unit, press the )520 menu
key to display a list of waypoints. Press the &85625 3$'
to select the desired waypoint and press the (17(5 key.
Finally, enter the bearing and the distance from the desig-
nated waypoint to the new waypoint.
If you change your mind and want to return to specifying
distance and bearing from your present position instead
of another waypoint, press the )520 +(5( menu key on
the waypoint list screen.
If you've travelled to a part of the world that's south of the Equator or east
of the Prime Meridian (running through Greenwich, England), the unit
automatically displays your lat/lon coordinates as
N W
instead of and . The
hemispheric values should it be necessary. When the cursor is flashing
LAT
anywhere in the
the hemispheric values.
5. Enter a name for the waypoint and, if you desire, a
description, as previously described.
6. Choose a symbol for the waypoint by pressing the 6<0
%2/ menu key until you find a symbol you want (see
"Assigning waypoint symbols" starting on page 75).
7. Press the (17(5 key to store the new waypoint in the
unit and return to the WYPTS CHART screen.
Chapter 6 - Creating Waypoints
NOTE:
16(:
key lets you manually change these
LON
or fields, press the
S E
or , respectively,
16(:
key to change
Page 77