951/952 Operator's Manual Rev. B
5. Before transferring, check the communication link
between the two units by pressing the 7(67 &200 key. If
the status bar now displays the message REMOTE LINK
OK, you may begin to transfer waypoints.
6. To move waypoints and routes from this unit into the
other unit, press the 67$57 key. The status bar displays
the message TRANSFERRING and updates every second
with the number of waypoints and routes sent compared
to the total quantity to be sent. The progress bar, located
below the status bar, graphically shows the percentage
completed.
If there is a problem with the transfer process, the follow-
ing messages may appear:
•
If the other unit is off-line, the master unit displays the
dialog-box message TRANSFER ABORTED BY COMMUNI-
CATION TIMEOUT and the status-bar message COMMUNI-
CATION ERROR.
•
If the master unit doesn't contain any waypoints and
routes, the master unit displays the dialog-box message
NO WAYPTS OR ROUTES TO TRANSFER and the sta-
tus-bar message NO TRANSFER DONE.
•
If the other unit is completely full of waypoints and routes
(no more room available), the master unit displays the
dialog-box message REMOTE UNIT STATUS ERROR [002]
Chapter 6 - Creating Waypoints
Page 95