ClimaRad Care H1C Additional Installation, Operation And Maintenance Instructions

Maintenance instructions ClimaRad Care H1C

Maintenance frequency for filters

When should you replace the filters?
• With normal use, every 2 years or earlier if the message 'Filter
on the display (for example in homes and offices).
• In the case of intensive use, after 1 year or earlier if the message 'Filter
vervuild' appears on the display (e.g. for care homes and schools).
Go to www.climaRad.nl/filtervervanging

Replacing air supply filters

1.First switch the device off by
pulling the plug out of the socket.
left
4. Open both valves by pulling
them towards you.
left
7. Put the two black filter caps
(left and right) back in position
and close both valves again.
Important: Only reset the filter hour counter if you have replaced the filters.
to view the instruction video.
2. Unscrew the locking screws
from the housing. The lower
housing now moves forward.
1 right
left
5. Remove the black caps.
right
1
3
8. Reinstall the air distributor (1),
tilt the lower housing back in
position (2), and tighten the
screws again (3).
F u t u r e c o m f o r t t o d a y
vervuild ' appears
1
3. Remove the air distributor.
Slide 3 new filters in
right
6. Slide three new filter elements
into the device on the left side.
The old filter elements are
automatically ejected from the
right side.
2
9. Put the plug back into the
socket and reset the filter hour
counter (Press + and –
simultaneously for 6 seconds). The
'filter vervuild
disappear.

Ordering filters

Order new filters at
www.climarad.nl/filters
3 old filters will
slide out
Press
and
for 6 seconds
' message will now