For details about mounting cameras to the AM-520, AM-525, and AM-527 brackets, refer to their Installation Guides. For cabling and configuration details with each network camera, please refer to their documentation. Installation IMPORTANT: The AM-218 has to be installed with the AM-714. You should also purchase the AM-214 conduit box and corresponding AM-520, AM-525, and AM-527 adapter.
Refer to the table below for the description of the included screws: Screw Description No. of Material char. screws M5X14 Stainless steel, hex and cross head NOTE: 1. It is presumed that this wall-mount bracket is installed with a hole drilled on the wall for routing power lines, DI/DO, and Ethernet cables.
Page 5
A 3/4" conduit is required for routing the cables with waterproof connection. Install the cable gland and pass cables through it. Form a drip loop when routing with the conduits.
Page 6
Installing the Bracket and Adapter 1. Route cables through the AM-218 bracket and the adapter (AM-520/AM-525/AM-527/ AM-528). 2. Secure the bracket to the conduit box using the included hex screws. 3. Secure the adapter by turning them clockwise. When done, fasten the hex socket screw to secure the connection.
Page 7
4. Follow the instructions in the Installation Guide that came with the adapter to install network cameras.
Page 8
Pole mount and corner mount are also supported. Please refer to their Installation Guides for more information. AM-312 AM-412...