Adjusting; Power And Air Connections; Initial Operation; Clamping Unit Of The Jaws - Launch TWC Series Manual

LAUNCH

Power and Air Connections

Before installation, check if the power source and
the compressed air are in accordance with the
specifications on the nameplate. Any electrical
connection should be done by the specially
trained technician.
The power socket should be at a place within the
sight of the operator. The advisable height is
between 0.6 – 1.7M.
In case the main voltage is not stable, a voltage
stabilizer should be used between power source
and the machine.
The machine should be well grounded.
The tyre changer is not equipped with
overload protection.
according to the circuit diagram included in the
User's manual. Otherwise, the manufacturer
will not be responsible for any accidents.
Please connect power

Adjusting

Attention:
Make sure that the power supply and air source in
accordance with the requirements.

Initial Operation

Note:
The four pedals must be kept at the original
position.
Press down the pedal "
clockwise;
Lift the pedal "
counter-clockwise;
Press down pedal "
release it to restore;
Press down pedal "
turntable; pedal again to move them inward;
Tyre changer with tilting post
Press down pedal " ", the tilting post will tilt
backward. Pedal it again to restore the tilting
post upright.

Clamping Unit of the Jaws

The position of the jaw (Fig.28) on the turntable
is controlled by the movement of the piston rod,
which in turn is controlled by pedal "
are three levels for pedal "
is placed on high, the piston rod will move inward
and pull the jaws moving inward until the
minimum.
When pedal "
will move outward and pull the jaws moving
outward until the maximum.
While the jaws in motion inward, press pedal
" " lightly to keep it at the middle level, the jaws
will stop in response. Do this function flexible to
get the jaws anywhere between the maximum
and minimum for different wheels.（For tyre
changer with tilting post）
36
Tyre Changer(TWC Series)
" to turn the turntable
" to turn the turntable
" to open bead breaker;
" to open the jaws on the
". There
". When pedal "
" is placed on low, the piston rod
Fig.28
"