Launch TWC Series Manual page 34

LAUNCH
Fig.11
Fig.12
Take out the cone, and assemble it with the fore
swivel arm as in fig.13.
Fig.13
Right Supplementary Arm
Take out assembly of back swivel arm, post and
lifting cylinder, remove the hood(fig.14). Then
take out disk assembly and relevant fastening
parts, apply lubricant on the fastening parts,
assemble them as fig.15, finally mount the hood.
Remove the bolts (fig.16) and washers on right
side plate of cabin, place the unit (fig.15) on the
seat vertically,
Fit washers and fasten them with bolts. Get the
PU hose out from the bottom of the
supplementary arm unit into cabinet through
small hole on its right side plate.
Take out pressure bar and relevant fastening
parts, brush lubricant on the parts, then
assemble
fig.17.
33
Tyre Changer(TWC Series)
Fig.14
Fig.15
Fig.16
them as in