Eighteeth UltraMint Pro User Manual page 19

1. Keep the device clean before and
after use.
2. Before each use, always check
that the device is placed on a secure
and flat surface. And adjust the water
flow to the maximum, and then start
the device to work for about 10
seconds in order to eliminate the
residual liquid in the liquid circuit.
3. The operator should take sufficient
protection (such as wearing goggles,
face mask, etc.) to prevent cross
infection. Use of an antiseptic mouth
rinse prior to procedure and use of a
high volume evacuator during the
scaling procedure are
recommended.
4. The use of the product must meet
the requirements of the relevant
operating specifications and relevant
regulations of the treatment
department, and is limited to the use
of trained professionals (such as
dentists) in the hospital or clinic.
5. Do not screw the tip, or pull out the
handpiece while the device is
running.
6. The tip must be tightened and
there must be fine spray coming out
from the tip when operating. Refer to
the user manual of tips for detailed
operating instructions.
7. Change a new one when the tip or
handpiece is damaged or there are
visible signs of wear.
8. Do not twist or rub the tip.
9. Do not use impure water sources,
and never use saline instead of pure
water.
5 Product function and use
10. If use the water source without
hydraulic pressure, the water surface
should be 1 meter higher than the
head of the patient.
11. Do not pull the handpiece cord
with force to avoid damage to the tail
wire.
12. Do not knock or rub the
handpiece.
13. After operating, turn off the
power switch and pull out the power
plug.
14. Always use original parts. Using
non original instruments may
damage the device, and operator or
patient may be injured.
15. No modification shall be made on
this product.
16. The ultrasound power must be
adjusted in accordance with the tip
used and the required treatment.
17. Always check that the cords or
cables will not rub against the front
face during the operation since this
could eventually modify the selected
settings.
Page 19 / 36