WARNING: Please read and understand all instruction before use. Retain this manual for future reference. Safety instructions ARC Rays can injure eyes and burn skin • Before welding, always inspect helmet and auto-darkening filter (ADF) to be sure they are fitted properly and in good condition. •...
Description of main parts Part # Description Delay Control Knob Sensitivity Control Knob Weld/Grind Switch Knob Self-test Button Low Voltage Indicator Shade Number Control Knob Battery compartment Solar Panel Arc Sensors UV/IR Filter Operating instructions Headgear Adjustment 1. Adjust the headgear diameter with the twist knob on the back. The knob is locked until pushed in. Once unlocked, twist clockwise to tighten and counterclockwise to loosen.
Part # Description Helmet Shell Front Cover Lens Rubber Gasket Retaining Frame Headgear Height Adjusting Pin Headgear Diameter Adjusting Knob Headgear Angle& Distance Adjusting Knobs Maintenance Front Cover Lens Replacement Replace the front cover lens if it is damaged (cracked, scratched, pitted or dirty). Remove the old front cover lens by pressing two Lock Switches at the bottom of the Retaining Frame and pull the frame and ADF out.
ΠΡΟΕΙΔΟΠΟΙΗΣΗ: Διαβάστε και κατανοήστε όλες τις οδηγίες πριν από τη χρήση. Διατηρήστε το παρόν εγχειρίδιο για μελλοντική αναφορά. Οδηγίες ασφαλείας Οι ακτίνες ARC μπορούν να προκαλέσουν τραυματισμό στα μάτια και να εγκαύματα στο δέρμα σας. - Πριν από τη εργασία συγκόλλησης, επιθεωρείτε πάντα την μάσκα και το φίλτρο αυτόματης συσκότισης (ADF) για να βεβαιωθείτε ότι είναι σωστά τοποθε- τημένα...
Need help?
Do you have a question about the PRO BIW2020 and is the answer not in the manual?
Questions and answers