To Cut And Paste The Text - NEC e808n Product Manual

To Cut and Paste the Text

To cut and paste text, proceed as described below:
To
1 Specify the cut function
2 Specify the cut starting point
3 Specify the cut ending point
4 Specify the paste point
5 Paste the block
Text Entry
Do this
Press the SK2 (Submenu) key in the text mode, then select
Cut.
Move the cursor to the starting point of the block to cut by using
the Up, Down, Left, or Right key and press the Enter key.
Note : You can cancel the specified cut starting point by
pressing the CLR key.
Move the cursor to the ending point of the block to cut by using
the Up, Down, Left, or Right key and press the Enter key. The
specified text is cut.
Note : A maximum of 512 characters can be cut.
Move the cursor to the paste point by using the Up, Down,
Left, or Right key.
Press the SK2 (Submenu) key in the text mode, then select
Paste.
Note : If the cut text exceeds the maximum number of
characters allowed in the field, the remaining characters
will be discarded.
-27-