Failure Display And Inspection - GASLAND chef IH12BF Instructions For Installation And Use Manual

27
Pans do not become
hot and appears in
the display.
The induction
cooktop or a
cooking zone has
turned itself off
unexpectedly, a
tone sounds and an
error code is
displayed(typically
alternating with one
or two digits in the
cooking timer
display).

Failure Display And Inspection

If an abnormality comes up, the induction cooktop will enter the protective state
automatically and display corresponding protective codes:
Problem
F3/F4
F9/FA
E1/E2
E3
E5
8350 Patriot Blvd STE B, N. Charleston, SC 29418
www.gaslandchef.com
The induction cooktop cannot
detect the pan because it is not
suitable for induction cooking.
The induction cooktop cannot
detect the pan because it is too
small for the cooking zone or
not properly centred on it.
Technical fault.
Possible causes
Temperature sensor of the induction
coil failure
Temperature sensor of the IGBT failure.
Abnormal supply voltage
High temperature of the induction coil
temperature sensor
High temperature of the IGBT
temperature sensor
www.gaslandchef.com
(844) 538-7890
Use cookware suitable for induction
cooking. See section 'Choosing the
right cookware'.
Centre the pan and make sure that
its base matches the size of the
cooking zone.
Please note down the error
letters and numbers, switch
the power to the induction cooktop
off at the wall, and contact a
qualified technician
What to do
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
Please contact the supplier.
Please restart after the cooktop
cools down.
support@gaslandchef.com